Connect-Tek CTIP-01 Specifications download pdf (Page 52)

Connect-Tek Over IP

Web

Controls on the Home Screen (Web)

Once IPMI is enabled and functioning correctly, a set of controls will appear immediately under the thumbnail

image of the host computer on the Home screen on the Web interface. NOTE that you must be logged in as

admin to use this feature. From here, you have four options:

Hard Reset: Equivalent to pressing the RESET button on the managed computer. The computer will

restart.

Power Cycle: The computer will power off, pause for a moment, and power on again automatically;

equivalent to pressing the POWER button off and on again on the host computer.

Turn ON: Powers on the host computer.

Turn OFF: Powers off the host computer.

VNC

If you are inside an active VNC session and are logged in as admin you can use the Bribar to access IPMI

features. You have two choices from the Bribar:

Reset: Equivalent to pressing the RESET button on the managed computer. (The computer will

restart.)

ON/OFF: Powers the host computer on or off depending on the current state of the host computer;

equivalent to pressing the POWER button on the host computer.

NOTE: IPMI may not automatically close the host computer software safely when you issue a reset or power

off command. Since these features are equivalent to pressing hardware buttons on the computer

itself, the computer will respond in exactly the same way. Always shut down your operating system

and application software normally before issuing an IPMI command to avoid data loss or corruption.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 58

No comments

Connect-Tek CTIP-01 Specifications Page 52