Connect-Tek Over IP
12
Step 4: Click on the Admin/Setup button then Network configuration (IP address, netmask, gateway).
Step 5: From here you can set the IP address as needed, as soon as you set your IP addresses up, simply
press Commit .
3. Serial Port (DCE)
Connect the rear-panel RS-232 serial port (DCE) to a computer that can be used temporarily for setup and
control. This serial port connection is not required once the unit is initially setup and configured. It is an
115,200 BPS (8N1) connection. A straight-through, 9-pin RS-232 cable is used, not a null-modem cable.
Comments to this Manuals